Drayton Digistat 3 Instructions Install The Appliance

Preferably it should be mounted on an inside wall, about 1.5m (5ft) above the floor, in a position where it can respond to room temperature but away from the direct influence of radiators or other appliances giving off heat.

RECEIVER TRANSMITTER Digistat Optimiser SET SELECT SIGNAL HEATING ON OVERRIDE 2 1 YES LEARN MODE CONFORMS TO THE ESSENTIAL REQUIREMENTS OF THE FOLLOWING DIRECTIVES: 89336EEC ELECTROMAGNETIC COMPATIBILITY 7323EEC LOW VOLTAGE DIRECTIVE THESE INSTRUCTIONS APPLY IN THE UK ONLY THESE INSTRUCTIONS ARE TO BE LEFT WITH THE USER OR AT THE APPLIANCE.

Drayton Digistat 3 Instructions Install The Appliance

Failure to install the appliance correctly could lead to prosecution.

IMPORTANT: Read these instruction carefully in order to get the best from your appliance.

WARNING: This appliance must be earthed and protected by a 3A fuse if a 13A plug is used, or, if any other type of plug is used, by a 5A fuse either in the plug or adaptor or at the distribution board.

TO FIT THE RECEIVER WARNING: Switch off the power supply before starting work.

Release the blanking plate by gently pulling the top lug and withdraw it from the front of the facia.

Present the receiver to the facia and plug the programmer connector into the four-way connection on the board (Fig.

Push the receiver into position ensuring that the lead is not trapped and that the top lug snaps into place.

Refit the control panel before switching on the power supply.

Turn on the power to the appliancereceiver.

Push the override button on the receiver once.

The green LED should come on and the appliance should run in central heating mode.

To enter the learn mode push (and hold) the button marked 1 followed by the button marked 2 (OVERRIDE) and hold both depressed together.

The red LED should flash for two seconds then go out signifying that the receiver is in learn mode.

Release both buttons.

The red and green LED s should now both be on.

Take the Digistat (no closer than one meter from receiver.) 6.

Repeat the same procedure with the left hand battery drawer.

The procedure on the right hand drawer must be carried out first.

As soon as both battery compartments are slid back into place, the red LED on the receiver should flash for 7 seconds and then go out.

The green LED may be ON or OFF depending on the room temperature at the time of commissioning.

The Digistat should now display the actual room temperature and the time at am midnight.

If the unit has been stored in a cold place, it may take time to warm up.

If the red LED remains on, slide down both battery drawers on the Digistat, check the battery positions are correct, and once the display has faded, repeat steps 6 to Increase the SET temperature on the Digistat by pressing the button until a flame symbol appears, in the left hand segment of the display.

The red LED on the receiver should flash for 7 seconds.

This confirms that the radio signal is being sent and received.

After 7 seconds the red LED should go out and the green one come on.

Check that the appliance is running in central heating mode.

Decrease the SET temperature on the Digistat by pressing the button until the flame symbol disappears.

After the 7 seconds both the red and green LED s should go out.

Check that the appliance has switched off.

The Digistat can now be secured to the wall in the desired position.

During normal operation the red LED on the receiver will flash for 7 seconds each time a radio signal is received from the Digistat.

Once the system has been successfully commissioned, buttons 1 and 2 on the receiver should not be pressed simultaneously, unless a replacement Digistat or receiver is fitted.

If the Digistat is being used to replace an existing hard wired thermostat, the wiring to the old thermostat must be made electrically safe and isolated, as it is no longer required.

LOCATION Care should be taken to mount the Digistat in a position which is not subjected to direct sunlight or draughts.

Drayton Digistat 3 Manual Instructions